To learn the Repeater into the Control Panel, slide DIP Switch 4 to the On position. The Repeater will emit 1 long beep and the Yellow LED will turn on.
Press the Test button. The Repeater will transmit a Test Code to the Control Panel as the Red LED lights up and the Repeater emits 1 beep.
If the Repeater receives an acknowledge signal from the Control Panel within 60 seconds, Learning is successful. The Blue LED will light up for 1 second as the Repeater emits 1 long beep.
Click on the blue device tile in the WMI to finish pairing.
After the device is learnt-in, put the Control Panel/Hub into Walk Test mode. Hold the sensor in the desired location, and press the Test button to confirm this location is within the signal range of the Control Panel/Hub.